7mm:1ft - 0 Gauge Railway Modelling.

By Raymond Walley
Manufactured by: Southwark Bridge Models, 7 Came Close, Chandler's Ford, EASTLEIGH, SO53 1HH.
Tel: 023 8026 2414,  07890 471158    ivansmith@talktalk.net    http://www.sbmodels.org/
I rate this kit as: 4-4-4

Introduction.              PDF version

Mooching around at Guildex in 2009 I happened across Ivan's stand and stopped by to say hello.  He had some new (to me anyway) Great Western items, one of which was a pair of platform seats with the old intertwined GWR cast into the seat supports.

 

I have a Great Western platform seat on my terrace and I can attest to its comfort but, mine is the later pattern based upon the shirt button.  Actually much rarer that the intertwined one.

 

Since my, largely, freight railway is to have at least a token passenger service, it seemed right to have a couple of seats for hapless passengers to rest upon while awaiting the infrequent steam railmotor or autotrain.

 

What's in the Bag?

what's in the bag?So, what's in the bag?  Two small sheets of etch and some simple instructions.

 

The standard of draughtsmanship is, as usual, very high and the etching is excellent too.

 

I was surprised not to find etched dimples in the seat planks to represent the bolt heads but I doubt anyone will notice their lack.

 

Construction

The seat supports are two mirror image etches so soldering them together is simple.  They fit well together.

 

Once soldered together and the cusps all filed off I mounted it in the two parts that makeup the base and soldered it in place.     Back to Top

 

This was done for all the seat supports as the picture below shews. One of the seat planks was lightly marked on the seat bases under constructionseat ends ready to be soldered uprow of seat ends ready for final worktop for centre and 7mm from each end.  All the others were simply marked for centre at 81.5mm.

soldering the seat back 1soldering the seat back 2close-up view of seat endsThen, using the trusty magnets to hold two supports, I carefully soldering the first seat plank in place across the outer supports and added the centre one afterwards.

 

Once the two seat plank were fixed it was a simple matter to turn the unit over and fix the top plank to the back of the seat supports, ensuring that each support protruded equally above the plank.

 

This close-up shot gives a good idea of how beautifully etched the supports are.

 

complete and ready for paintingHere is the completed seat awaiting a trip to the paint shop, but not until I have decided upon the station name.

 

A nice little item - two really since there is a pair in the bag - well up to the standard one has come to expect from Ivan.          Back to Top